LupoBoy321 Posted December 8, 2010 Report Share Posted December 8, 2010 whats the best coiloversi could get for around £250-£300 ?? Quote Link to comment Share on other sites More sharing options...
Philplop Posted December 8, 2010 Report Share Posted December 8, 2010 I would say either go for the cheapest you can get, which are just over £200 I think, from philj on ClubPolo, or save up a bit more and get AP's. Most of the cheap ones are the same, just stickered up with a different name. Quote Link to comment Share on other sites More sharing options...
Lermy Posted December 8, 2010 Report Share Posted December 8, 2010 get AP's mate they go low and the ride is good Quote Link to comment Share on other sites More sharing options...
LupoBoy321 Posted December 8, 2010 Author Report Share Posted December 8, 2010 wats the lowest they go the AP's mate and cost? Quote Link to comment Share on other sites More sharing options...
Lermy Posted December 8, 2010 Report Share Posted December 8, 2010 wats the lowest they go the AP's mate and cost?they are £413 80mm on front 70 on back i think Quote Link to comment Share on other sites More sharing options...
Deadmetal Posted December 8, 2010 Report Share Posted December 8, 2010 They go lower than the stated numbers. The lowering mm they state on websites it the TUV approved drop. Pretty much all coilovers will go lower than the amount stated.I'm running Aps and they are worth spending the extra on. Even with no adjuster in the back and nearly all the way down on the front, they still ride pretty well. Quote Link to comment Share on other sites More sharing options...
LupoBoy321 Posted December 14, 2010 Author Report Share Posted December 14, 2010 could any of you tell me of some budget coilovers that go lower than 90mm? Quote Link to comment Share on other sites More sharing options...
Ben™ Posted December 14, 2010 Report Share Posted December 14, 2010 They all go lower than 90 on the front, just not tuv approved. Quote Link to comment Share on other sites More sharing options...
LupoBoy321 Posted December 14, 2010 Author Report Share Posted December 14, 2010 ohright wat and the back, does it do damage then or will they **** up if i go lower mate? Quote Link to comment Share on other sites More sharing options...
LupoBoy321 Posted December 17, 2010 Author Report Share Posted December 17, 2010 im looking to buy some wheels but dont know which ones :/ but i was thinking does it matter wat size the wheels are or anything else as long as its 4 stud? Quote Link to comment Share on other sites More sharing options...
Deadmetal Posted December 17, 2010 Report Share Posted December 17, 2010 Of corse it matters, diamter, width, offset, pcd, center bore.You want 4x100 pcd.15s and 14s seem to be the best sizes to fit.7j is the most common width that'll fit with fewest probs.Standard lupo offset is 38, so closet you can get to that should give you less probs.Im pretty sure the center bore is 57mm, bigger and you can get spigot rings, smaller and you will need to get the hole made bigger. Quote Link to comment Share on other sites More sharing options...
LupoBoy321 Posted December 17, 2010 Author Report Share Posted December 17, 2010 umm.i was wanted to get some 13x8 and my mate said i need some spigot rings and wobble bolts but i dont know were i would get some from ?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.