crashtestdummy

I guess this forum is dead these days. I've solved the issue now via the 3L page on Facebook

Thanks, I hope he can help!

I need some help with my non starting Lupo 3L 😟 It's been stood a while with the battery disconnected and on charge. It's a new battery showing decent voltage. When I went to start it absolutely nothing happens. The starter does not turn at all. I've tapped the starter solenoid to see if it's sticky and no change I adjusted the clutch to 1.90v in basic settings as it was showing 0.72v Then I went on to do a gear actuator adaptation and it failed showing RTFM and fault 12... Are there any good guides on what I need to check and adjust for fault 12? I'm extremely new to all this and to using VCDS so please go easy! Thanks in advance 🙂

Hello?! Nobody knows?

My cat finally gave up and I bought a replacement my my local motor factors. The old pipe had an O2 sensor hole just after the cat but the new pipe doesn't have one. I know some cars have a sensor on the manifold AND post cat but you don't need the one post cat. Is this the case here? Thanks, Scott

Ok found one on ebay ELSAWIN version apparently ebay clicky

Ok... so is there another manual available? Ie Bently or auto data?

Need a decent manual as i'll be doing all the maintenance work on my girlfriends 1.0 Lupo. Couldnt find a haynes manual in halfrauds and the manual list didnt show one. Do they exist? Cheers, Scott