new member looking for some advise

[KP13]

firstly, theres a problem with the driver side electric window button, it opens the passenger window but not the drivers side even though you can here the motor clicking,

also the door lock wont stay in after i fitted a new key kit to fix the lock, but then when putting it back into the door it wont secure in and falls out easily

and if i remove the bump strips on the doors what will i be left with under them?

and finally is there any guides on how to fit an induction kit on the lupo 1.4s ?

any advise will be very helpful

cheers

Edited June 14, 2013 by KP13

[KP13]

also ive taken off the trim on the dash to spray and after spraying the T section part wont fit back in, any advise?

[Rich]

Have you tried a hammer on the t section ? Just a small one ?

I used a toffee hammer to put the dash bit back in, it was well sweet.

[aaarosa]

Set up a target at the other side of the room then cut off all the mullered plastic welds from the t piece and see what score you get :-) they don't half fly but it will sit flush again

[Coley220]

yeah that target idea is a great! needs to be good 3m away tho!

on a serious note tho, cut of the plastic welds and glue it back down in the corners and areas struggling to sit flush with super glue or evostick(clear)

[KP13]

cheers guys, will try it when i get home