vDKx

It turns out I was a tooth out on cams and a tooth out on crank but cheers for your help its all good now

I had crossed wires ive done it now but its still not spot on how long did yours take to take effect properly? It is better though just not spot on

Bought one from uni part and its completly diffrent why is this cheers?

What coulor sensor did you change, the green ome on front of head? Cheers

Ok ill try it thanks Ok ill try it thanks

Hi I'm really stumped Recently my cambelt tensioner sheared off while I was doing 30 mph so I smashed all the valves to bits so I had to rebuild the head its got all new valves new seals new head gasket new head bolts new belts a full cambelt kit and while I was at it I discovered my oil separator was bugared so I replaced that too now I've come to run it again and the engine is over fueled and running rough on tick over but it's fine when reving properly I've checked everything sealed properly so it's not drawing air anywhere its really stumped me I don't have a clue what it is it seems like it thinks it's cold all the time so runing really rich like asif it had a choke stuck on I could really do with some help cheers Kendell

Ive just bought a marvel reversable one for mine so im going to try cover my Door cards with the back

Im 21 and pay just short of 2k for a lupo sport

It was fine before I sorted the head and its definatly running on all 4 ill just let it run in before I make any presumtions ill just keep an eye on things thank you very much for your help

Ill just have to have a look at the linkage tomorow I did drop a bolt off the bracket under the coil.pack and I used a very large magnet on a steel bar to locate it as I couldnt see it so I just jabbed about so I might have done something then cheers

The pedal feels fine bar the juddering which only happens at bite and dont worry about long replys im just grateful for the no matter how long the reply is

Id doesnt stick the pedal just vibrates and feels wierd cheers Oh and I have 1.4 16v sport AUB

Hi I have spent the last 3 days stripping the head off my engine to do all the seals as it was burning oil I spent hours cleaning and lapping the valves then cleaning the head and pistons put it back together fired it up all went fine went to set off and the clutch pedel was juddering and obviously I didnt touch the clutch and it definatly didnt do it before any help/advice would be much appreciated cheers. Regards

hi i am trying to find some gti cards and quarters so i can have speakers in the back without having to cut a hole in mine and also it will still match front and back? cheers

Ive compression tested it and all is fine so I will order some valve stem seals and do that give it a service and a cam belt roo cheers