aziz360

I have had my car looked at by a vw specialist garage. they have diagnosed it as an ecu fault after checking all the electrics. will hopefully be getting a new ecu soon

Ok thanks will give it a go tomorrow

Ok thanks how will I go about doing that? Will I have to put it on voltage stick probe in the obd pins and other probe to an earth?

i have checked most of them dont know which ones to check really. i have checked the obd port which is fine as it does connect to abs etc. any ideas on what other fuses i can check? thanks

I have tired snap on tool, vcds and also vw tried connecting to it. Will connect to everything else airbag abs etc. just not engine.

I'm probably completely wrong but my golf used to do it sometimes and it was because when I pulled the key out the two connect in the barrel kept getting stuck and didn't come together Sorry meant to say 2 contacts in the barrel

Hi i have a lupo 1.4s aua. i can't connect to ecu and was wondering if anyone has the wiring diagram for the ecu, or if anyone knows which colour wire/wires will go from the ecu to the obd port. Thank you

Hi I did what you said. Let it idle for a couple of mins switched it off. Turned it straight back on the epc light went off and car is idling smoothly and throttle is working. Thank you everyone for your help

Just to let everyone know. I started car let it idle for couple of mins switched it off, turned car straight back on epc light has gone off idles smoothly and throttle is now working!!! Thank you to everyone for your input.

Just to make sure I put it on with the black cover facing towards the engine can anyone confirm that is correct. Thank you

There isn't really a lot just the 4 bolts that hold the throttle body on and the connector to it. Going to try throttle body alignment on it tomorrow.

How long will I new to leave it running for. Until engine is hot ?? Thanks

Hi I took the throttle body off. And cleaned it. I'm sure I put it back on properly the black cover facing towards the engine. I didn't clean the egr.

Hi I have a lupo 1.4s 2001. I cleaned the throttle body because it was filthy. Now wen I start car epc light is on and i put foot on accelerator it will rev but then after a few minutes the accelerator pedal stops working. Put foot down on accelerator and nothing happens. Please can anyone help.

Hi I have a lupo 1.4s 2001. I cleaned the throttle body because it was filthy. Now wen I start car epc light is on and i put foot on accelerator it will rev but then after a few minutes the accelerator pedal stops working. Put foot down on accelerator and nothing happens. Please can anyone help.