aaron.hoppy

I cleaned it with carb cleaner but it still looked rough. I think you may be right. Its 5 wires and a 6 pin plug, Im going to my local parts store to check it tomorrow. Thanks!

Hi there, Today my car failed its MOT on emissions, I believe its the Pre cat lambda sensor and so does the mechanic, I removed it with the intention of replacing it today however I can only seem to find 4 pin/4 wire and the one I have removed is 6 pin but I cant find one anywhere!? I have searched around and cant find one... My car is a 2002 seat arosa 1.0, If anyone knows where I can buy one I would very grateful! Cheers

Yeah just needed a new horn! simple to replace and I got one from my local breakers yard for £2!

Hi all, Went to use my horn yesterday as some twerk cut me up, I hit the wheel and the horn sounded for around a second - if that before cutting off and now it doesn't work. I can't seem to find any threads on it. I have checked the fuse and it was fine but replaced it anyway. Still no luck. Can someone tell me where the actual horn is? I want to test it to see if the horn has failed. I had a look in the bay quickly last night but I can't see it! Any help would be appreciated! Thanks for your help

Hi all, Went to use my horn yesterday as some twerk cut me up, I hit the wheel and the horn sounded for around a second - if that before cutting off and now it doesn't work. I can't seem to find any threads on it. I have checked the fuse and it was fine but replaced it anyway. Still no luck. Can someone tell me where the actual horn is? I want to test it to see if the horn has failed. I had a look in the bay quickly last night but I can't see it! Any help would be appreciated! Thanks

Hi all, I need to remove some spray tint on my rear lights but I want to remove the whole unit off the car so not to damage any paintwork. I believe its quite simple just don't really know how can someone tell me how to remove the rear lights? Thanks

I done some of my own alloys and used E-Tech alloy spray paint off ebay, it takes 2 tins to do 4 wheels and its really good stuff, they do a few different colours. Its different to normal spray paint, much tougher and even doesn't look rattle canned like cheap spray! take a look on ebay its about £6.00 a tin but is well worth it!

Hi, Got a nasty dent on my door and its getting more and more annoying! Was wondering how to get off all the inside door card. The dent is right up next to the handle so the top door card bit Any help appreciated! Thanks

No it isn't like that davie18, its more like a helicopter or airplane overhead but not as loud like a plasticy clattering when engine breaking at all speeds and when I engage clutch it goes. Thanks though

Tried videoing it but its too quiet in the video! and I have to be driving for it to make the sound :/

Hi everyone, So when I stop accelerating there is this kind of rattly sound, almost sounds like a plane is flying over head... its not that loud but its most times a slow down. If i put my foot on the clutch it goes away and it also goes if I accelerate. Anyone know anything?

There is thread on here about how to clean the EGR valve, sometimes they get clogged up with smut and a good wash through with carb cleaner can sort it out. Just take of the EGR valve and fill it with carb cleaner, close up the ends and give it a good shake and let it rest for 10 minutes then shake it again and pour all the remaining liquid away. It makes the car run nasty for about a minute as it burns off all the impurities but after that it will go back to normal. Sometimes it works sometimes not! but by far the cheapest way!

Was that exact one I used! the glue just shatters before it pulls the dent

Thats possibly the most beautiful response aha

SO YEAH THANKS FOR YOUR HELP EVERYONE aha, just turned into a testosterone fuelled rant thread.