Jump to content

Replacement side indicators


Starquids
 Share

Recommended Posts

So my sons Arosa had mis-matched indicators, with water ingress. 

Easy to replace, but let’s do it properly. 

1. Remove wheel liner. Ours are missing, 🙄

2. Disconnect earth lead from battery. 

3. Push indicator forward & out from wing. We discarded the whole of the old unit & cut wiring back to Seat original. We push this back through into car below windscreen. We added 5A fully insulated bullets, joined the new wiring & heat shrunk it to seal. We cable tied this to wiring loom to keep it tidy. 

4. Put on hazards to test & then clipped new light unit into wing. 

5. Stand back and admire!! 

19BD4479-4F7B-4C4B-8FFA-2012710E5DC9.jpeg

BBE08FF0-1DC0-4A37-A17C-A94A2B2D31A9.jpeg

4EDB0453-7ACB-45F7-B888-72F60C6381F6.jpeg

Link to comment
Share on other sites

  • 11 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.