Jump to content
WatchThis

Remove rear bumper - help needed!

Recommended Posts

Hi,

I need to remove the rear bumper from a 59 Fox. I've undone the torx screws along the bottom and in the wheel arch. I've then removed the two hex head screws on each side that screw up into the body and also a hex head screw (that I'm not sure I needed to release) that screws into the body parallel to the ground.  The bumper won't release - it looks like theres something holding it about an inch from where the top of the bumper 'dips' for the boot opening. I've stuck my hand up there and I can feel something thats kinda triangular but there's no hex head. I've given the bumper a tug and stuck a trim release tool in there (both sides) but it's not keen on shifting..

Any advice, tips or hints? Thanx

 

Share this post


Link to post
Share on other sites

Thanks Lupo, but the attachments won’t open for me. I get “

Sorry, there is a problem

This attachment is not available. It may have been removed or the person who shared it may not have permission to share it to this location.

Error code: 2C171/1

Share this post


Link to post
Share on other sites

i remember there being **** 10mm nuts everywhere, take the arch liners off and have a good look about.

Share this post


Link to post
Share on other sites

Thanks Rich - I’ve only taken enough of the liner to get my rather massive hands into, but I’ll remove all of it - Thanks

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.