Jump to content

Search the Community

Showing results for tags 'fuel'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Site Info
    • News and Announcements
    • The Archive - "How to" and "Information"
    • Site Suggestions
    • CL Merchandise
  • Club Lupo Social
    • New member?
    • Spotted
  • Model Specific
    • Volkswagen Lupo
    • Volkswagen Fox
    • Volkswagen Up!
    • Seat Arosa
  • Lupo and Arosa
    • Tuning
    • Styling
    • Interior and In-Car Entertainment
    • Car Care, Maintenance and Mechanical
    • Events
    • Member's Cars
    • Photoshopping
  • General
    • Drivers Lounge
    • Automotive Chat
    • Tech and Photography
  • Marketplace
    • Marketplace
    • Insurance

Calendars

  • Events
  • Birthdays

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


My Car Diary


Currently Driving

Found 10 results

  1. Bit of an odd one here.. AUC 54’ plate 1.0 MPI Arosa 124,xxx miles Its recently become really hesitant when setting off or putting your foot down. It’ll hesitate for a few seconds then pick up. Sometimes it’ll also just rev itself between 500-1000RPM. It also shakes sometimes at about 500rpms From what I’ve read on here most people say it’s either the HT LEADS, COIL PACK, or SPARK PLUGS. Plugs were done about 20k ago and gapped correctly. I am planning to change these soon and see if it changes anything. My main concern though is that there isn’t an EML on the dash when the car does this?? Does this mean it’s not likely to be missfiring and it’s not those parts causing the issue Anyone able to help? thanks
  2. Hi,I have a problem on Lupo 1.0 AUC 37kW with fuel mixture. VCDS showing error:17560/P1152 - Long Term Fuel Trim Additive Air; Bank 1; Range 2: System too Lean17573/P1165 - Long Term Fuel Trim Additive Air; Bank 1; Range 1: System too RichAfter clearing these errors they comes back in few days. In a month comes on engine light too. Last time I cleared errors I looked on oxygen sensors learning values: -6% on idle and +24% on partial load. The strange thing is that readiness is absolutely OK. Any suggestions? I'm little bit helpless at this moment.What have been done:- new oxygen senzor- cleared throttle body- replaced some bad looking hoses- cleared manifold preassure senzor- changed fuel filterPics from VCDS there: https://imgur.com/a/ZehuiX5
  3. According to volks world (ssp_223) the t piece allows the 1.4 to warm up to >30ºC whereas the 3L gets up to ~60ºC before returning fuel back to the tank Checking through etka based sites like partsbase.org and partscats.info it comes up with the P/N 038906081B for all of lupos diesel engines and also covers many others Vag models. Does anyone have any idea how there could be two with the same P/N Does anyone know of the alternative that may have been used in the lupo/ A 1.2 3L Thanks Keelan
  4. Having recently searched for a guide on changing the fuel filter on a 1.0MPI Lupo and not finding one I thought I would throw together this little guide based on one I found for a polo. Apologies if there is one out there and I've missed it Its not the hardest of tasks but sometimes its useful to have a few pictures and steps. - First step is to either jack the rear of the car up and support it on axle stands or roll the rear wheels onto a set of ramps / sturdy wood blocks. Though not 100% necessary even another couple of inches clearance will make this task a lot easier. - Unplug the fuel pump, This can either be done by removing the fuse in the fuse box, or unplugging it from under the rear seats. - Next run start the car up and run it until it stalls, removing as much fuel as possible from the fuel lines. - finally loosen the fuel filler cap to release excess pressure - Look under the back of the car just next to the read drivers side wheel (UK), you will see this little beast clipped into its bracket. - Give the screw a heavy coating of WD40 and go and make a brew whilst it soaks in - Unfortunately for me the screw head was well beyond functioning so I had to dremmel a new slot into it. (Remember to have a suitable fire extinguisher on hand when doing any cutting near fuel lines) - A good tip when dealing with dodgy / corroded screws is to use a rubber band in between the screw head and screw driver - http://lifehacker.com/5462520/remove-a-stripped-screw-with-a-rubber-band#c18998275 - Now the fuel filter is free you should be able to drop it down out of its bracket - Press in the small button on the fuel line clip and pull the fuel lines off the filter. Expect a bit of fuel remaining in the filter to flow out when undoing the lines. Not entirely sure what the white clips that came with the filter are, couldn't see a part like them in my fuel line fittings... possibly for a variant model or Seat. New screw and washer, ideally would have liked a hex head / allen head bolt but this will have to. - Finally ensuring the arrows on the filter are pointing in the correct direction (Forward in my case) push both of the fuel line clips back onto filter. you should feel a good click when correctly installed. - Pop the filter back into its bracket and tighten up the screw, I also applied a good coat of vaseline to the screw head to make it easier to replace in later years when I forget i'm not driving my diesel polo and fill it up with derv. - Plug the fuel pump back in, replace the cover, and tighten up the fuel filler cap, and give it a crank over, it should fire up after 2 or 3 attempts! Disclaimer: This guide is not an official guide, and though a fairly easy task if you are not sure about anything make sure you ask for help.
  5. Just noticed this morning after filling up the tank that the fuel gauge is stuck right at the bottom. I'm thinking that it could be the gauge its self or the fuel sensor in the tank? Not too sure though. Has anyone else had this problem and found a fix for it? or know how i could go about fixing the issue? Any help would be great, Thanks, Adam
  6. Right I was just wondering what the other 1.0L Arosa's manage to get from their fuel. Half a tank last me 120 miles MAX! Now I don't know if this is normal or if my fuel efficiency is just ****?! Also had a few times where the petrol light has stayed on, regardless of the fact the tank was full! Help me y'all thanks
  7. Been having a few issues with my Lupo 1.4s (2001) and recently had the crank sensor changed This has solved most of the issues, but now my speedo isn't working at all, it sits at 0 and my milage hasn't moved at all, i didn't drive far but it should have at least registered something. the fuel gauge seems to be acting up slightly, only really when i go round corners it drops a fair bit, i know this will be normal cause it's going away from the pump, but it never used to do it. rev counter & temp gauge still working fine. used a diagnostic to check it, can't remember the code but it said something like 'Speed sensor A' any help would be appreciated, thanks in advance
  8. Hi, over the past few days my lupo has occasionally decided it doesn't want to start. The ignition will turn the engine over but I've had to pump the throttle a few times before it will eventually come to life. Also its not just starting from cold, the other day i drove to the shops, left it for 20 minutes, came back and it wouldn't start. any ideas?
  9. Went to buy some porsche tombstones for my lupo today after making a deal with a guy on ebay, finally got to his house after getting lost and he tells me that he forgot to take them off ebay and someone bought them on buy it now! FUMING. Then thought all is not lost as on my journey i was going to swing by an old scrap yard that said they had a mk5 golf bootlid for me, and when i got there, no handle. So it was no use to me So after a quarter tank of fuel later i return home empty handed. what a rubbish day!!
  10. Hey everyone Brand new member so forgive me any newbie mistakes!! I've had my littlw 1.0 Lupo E from back in 2000 and I was just going to drive her and drive er, eventually into the ground, with minium upkeep (and enjoyment). But something recently made me change my mind. No idea what it was, but I've made a start by using aluminium body filler to fill up a couple of cracks that were previously covered by masking tape. They've now been sanded flush, sprayed and lacquered and the car looks ten times better already. My burning question is...LPG!!! Liquid Petroleum Gas conversions for our beloved Lupos??????????? I've only been considering this the last few days and am amazed by the info and number of specialists already out there. Had a quick check on costs and LPG Wales do it for £620. Now i'm not sure if there's a huge difference in that or going somewhere else and paying £900 - i'll have to do more research. Also waiting for a few other companies to get back to me with quotes. As expected there are many 'DIY Kits' on Ebay. There's NO chance i'd be able to do something like that but does anyone have any other thoughts? Love to hear all comments - for and against LPG with reasons why. Thanks so much for your time guys. Cheers, Mark
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.