Benny

Don't know if this helps but on the rear is a 175/60 14 and on the front is a 155/55 14

I run the nankang NS2's 155/55 14's on my P slots and I find them to pretty good. They actually seem to have more grip than the 175/65's i'd been running previously!

I've just had mine done at a dealership in Norwich. They were more than helpful and got a courtesy car too!

Isn't 4 wheel alignment a bit of an overkill on a lupo as you can only adjust the toe and camber on the front wheels?

It says they do in here, try page 20! http://www.volkswizard.co.uk/images/cars/l...po_brochure.pdf

The lowest part of the sill is 100mm from the ground at the front and the rear. I might have a go at compressing the rear springs to get a little more ground scraping!

Well said!

I'm not really sure, it's got TA Technix coilovers with the rear adjusters out. I'ts no lower than alot of the beasts on here, I think it's because of the steels it looks low! Do it!

I'm getting about 45 mpg out of my 1.4 I'm trying to get more, will a re-map definatly improve the mpg and who or where is the best place to get it done?

That is a good point 155 is a bit of a small footprint! The 165/55 seem like an option, and they're only £40 each!

Does anyone have any pics of a 165/ 60 14 on a 6j rim? This question may have been asked a million times but i'm desperately in need of some tyres for some p-slots and am not sure wether to go for a 155/55 14 or something wider although I would like a little stretch! If anyone has any suggestions it would be greatly appreciated!

I've got the same problem with my black lupo. It's not quite as bad as yours. I tried flatting it down with 3000 paper and then mopping it, with no luck! It is definatly under the laquer, I've come to the conclusion i's gonna need another lick of paint!

Trying to get lower but need some rims badly!

Getting there, may need to find a bigger kerb?