StubbsGTI
-
Posts
34 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Posts posted by StubbsGTI
-
-
what happened to the xxr's
Was time to move on! Still got them though
-
More lows and more fitment
Have a photo.....
-
1
-
-
-
Few more changes over the winter
Boot install is finished
There's more camber
I'm now representing Cast13 running there new 17x8 RB1's
-
i saw this car on something else the other day!! thought it looked f**king awesome! need to see it in person!
what are the wheels?
might need to invest in a set
They're xxr 527 8.25x15 et0, I wasn't sure on them but love them now
-
Couple more photos of it
Also it's now bagged running V2
-
Picked up my new seats the other day and got them fitted
Raemco full carbon frame with Alcantara fronts
-
I could tell you what it is but if you don't understand box threads . .. . . . .
http://www.justdiesels.co.uk/gearboxes.htm
Terry should sort you out.
What would you say the problem is?
Thanks for that but I could probably do with somewhere more local, I'm in the midlands
-
I've had a read through the gearbox thread but couldn't relate to it. There's no whining or anything like that from my box, all gears are fine except 3rd. I can go up gears absolutely fine, but I cant change from 6-3 5-3 or 4-3, but I can get down into third by putting the clutch down, going into 2nd, then into third and let the clutch off. Could this be syncro's or something like that? Any ideas what it could be and how to fix it?
-
Couple more changes happened before edition to the old lupo.
Chrome front badge again
XXR 527 8.25 et0 all round
-
Had it fully stripped and dipped? Not sure on the process but if it's how it sounds I'm assuming that's the only way. Strip it down to the shell and dunk it like a biscuit.
Haha... Sadly no. It's done exactly the same way you'd spray it normally
-
Very nice, is it sprayed or wrapped?
It's plastidipped mate
-
Not much going on with the car at the minute, more camber and more lows happened the other day though
-
i'm 18 and it cost me £50 on my GTI to declare my coilys
-
-
-
joestubbss
-
much easier than I expected doing it that way, just take you time cant go wrong...
-
-
I get gallons per mile in my gti
-
Heat gun and mallet!
-
Give this a read mate, Should explain it.
Cheers man!
-
Drift works! Great service and couldn't find them cheaper anywhere else
-
Been running shims for a while now but they just don't give me the camber I want and I want to get lower on the back. I've looked everywhere for info on washers but no where seems to have a good answer. What width washers would I need to give me about 5 and half degrees of camber? And what size would they need to be to fit properly?
wide wheels
in Styling
Posted
Rota Grid V come in 15x8 eto0
And XXR 527's 15x8.25 et0
Can pick both sets up pretty cheap too