Johnwin

I NEED TO PUT THE REAR ADJUSTERS ON MY LOOP..IV BEEN RUNNING IT ON 13'S BUT NOW I WANT MY WINTERS ON AND THEY ARE A BIT BIGGER..JUST NEED A BIT OF DIRECTION AS TO HOW TO PUT THE REAR ADJUSTERS BACK IN.CHEERS JOHN

got a sdi for sale mate..£2500 everthing going for it.its in for sale section 202 sdi mattig coilovers or look in my topics.cheers

also fancy doing a stud conversion..any ideas where to get hold of the gear..cheers

What size wheel bolts will I need on a 1.7 sdi lupo..mine are looking shabby..I'm going to invest...cheers all

HI THERE GOT SOME MATTIG SSF MINGHT INTREST YOU...THER 7'S ALLROUND BUT STAGGERED OFFSETS..THE REARS ARE ET 3 WICH SIT AWSOME..THER PAINTED GLOSS BLACK AT THE MO AND ARE IN AVERAGE/GOOD CONDITION...NANKANGS WITH A BIT OF STRTCH ALLROUND..CHEERS

well said too many people dont realise the cost involved

FOR REAL

well what wheels are they

CLASSSSSSSSSSY!

Re-map thats about it dude..without spending silly moneys

13S Are the way forward..gets a bit bum twitchy at times but well worth it..commitment! haha

im from sheffield mate..lupo sdi on coils very low,wide,black mattigs,you will see me scraping about at some point

SCAFFY BAR,HEAT GUN,JACK AND BIG BALLS.HAHA.BE PREPARED FOR PAINT CRACKING!

whats ur location mate

id just be happy to be on stands tbh.haha

Nice one that sounds like a plan then

Iv been on here a while now..been modifying the lupo a fair bit and think it's time to take the next step...haha..wanting to come to a few shows..been to a fair few shows before but kinda sick of been stuck in the car park..this may seem like a daft question to the seasoned pros on here but how do I get into the shows with you guys..haha..I no this isn't possible at all shows due to limited space on stands etc but would be nice to get in for a few..the car is presentable..running very very low on coils with13x7 mattigs with a pretty good offset of 3 on the rear...loads of other bits and bobs always kept in good nick..any Info would be great...I'm in sheffield so i'd also like to get 2 some local meets..cheers

id be in mate..keep us posted

Thanks for the advice shall bear all that inmind..giving em a go 2morow..wish me luck.haha

Need sum tips/tricks to diy roll my arches..need to do em asap!!haha cheers

I'll chuck sumat up in about a hour..watch this thread..

The top of the tread is just about covered by the top of the arch..reckon that will keep em off my back??cheers

Hi all..going to be running a slight amount of poke on the loop..were do I stand with the law..the poke is very slight but if i get a arsey copper..what can I expect??a producer..warning..fine..points??any helps would be great..cheers john

Hi mate..I work in a plumbers merchant and was a plumber before that..before you change the boiler you could give a pressure equalizing valve a try..£80-£100 usually..failing that a new boiler supplied and fitted you would usually be looking at about £1200 (that's a combi out combi in swap)..and there is no doubt in my mind that vaillant are the best on the Market by a long stretch..if it's a flat you will only need there smallest combi(pro Eco tec 24)..or failing that you can't go wrong with broag and baxi/potterton..hope this helps..cheers john

ok thanks mate..just gives me a rough idea how mine will sit