Scooby Towers

All parts suit a 2004 Arosa. P&P at cost or you can collect from Lancashire (J30 M6 or J7 M65 are my nearest Motorway junctions - 15 mins from each) Window Switch - not the surround just a new rocker switch that is approx. 3 months old. Rear Headrests. Pollen filter - Full mounting kit including plastic surround, filter, filter holder and scuttle panel cover. Air Intake pipe and rubber surround that fits to inner wing. 2 Air Filter bolt covers (ie plastic discs) – one lug broken on each (normally 4 on each) but they hold ok on the remaining 3 lugs. Black Original OEM floor mats including the 4 large plastic holding screws. The rubber backs had started to degrade so have been covered in duck tape to stop further deterioration but look ok when in place.. Parcel shelf (no holes cut for speakers). Boot floor board / cover / carpet. If there no interest in the next few weeks all bits will be off to the tip.

No interest ?

All parts suit a 2004 Arosa and I'm open to offers on price. P&P at cost or you can collect from Lancashire (J30 M6 or J7 M65 are my nearest Motorway junctions - 15 mins from each) Window Switch - not the surround just a new rocker switch that is approx. 3 months old. Space Saver Wheel, plastic wheel riser and central holding screw. Rear Headrests. Pollen filter - Full mounting kit including plastic surround, filter, filter holder and scuttle panel cover. Air Intake pipe and rubber surround that fits to inner wing. 2 Air Filter bolt covers (ie plastic discs) – one lug broken on each (normally 4 on each) but they hold ok on the remaining 3 lugs. Black Original OEM floor mats including the 4 large plastic holding screws. The rubber backs had started to degrade so have been covered in duck tape to stop further deterioration but look ok when in place.. Parcel shelf (no holes cut for speakers). Boot floor board / cover / carpet.

Perfect Collection wise - I may be able to arrange something with CJ1 as he's near me when it comes to the motorway network (J30 M6)

I'd be interested in the front section of exhaust inc the CAT if its available ?

are you in Birmingham ? I only ask as wasn't the last picture on your fist post taken in Clitheroe ?

Try J & J auto Salvage Wellington Mill, Bolton Rd, Blackburn BB2 3PZ Tel: 01254 680563 They had a green Lupo in a few months ago - it maybe still there. Good Luck.

Call Joe 07708029856. He's based in Accrington and should have everything you're after. Say Hi from me (Chris with the Blue Subaru).

Hi Naomi, I'd happily give it a good home. My Son is 16 and my Daughter is 15 so it would be an ideal car for them to both learn in. It would also give me a year to fix any problems and ensure its safe for them to drive etc. I definatley would not break it, or sell it on, and would pass it onto my sister for her kids to learn in after my two. Obviously other peolple are interested, so I'm happy for my name to go in the hat; just shout if I'm lucky enough to be picked. Chris

Joe in Accrington will have both bits available - Tel - 07708029856

Set to with a hole saw

On the mainroad from Accy to Clitheroe. Very nice looking Red Lupo - only spottted it was lowered and has dished alloys as I was heading the other way. Anyone from here ?

You can pick them up for less than a tenner. I got one similar to the link below - works fine and has cleared several cars codes (mates cars at work etc) http://www.ebay.co.uk/itm/like/161330057943?adgroupid=13585920426&hlpht=true&hlpv=2&rlsatarget=pla-144471715506&adtype=pla&ff3=1&lpid=122&poi=&ul_noapp=true&limghlpsr=true&googleloc=9046586&device=c&chn=ps&campaignid=207297426&crdt=0&ff12=67&ff11=ICEP3.0.0-L&ff14=122&viphx=1&ops=true&ff13=80

Will the standard front pipe (inc CAT) from a 1.4 Lupo or Arosa fit a 1.0 MPI Arosa standard manifold and centre section ?

Still looking

Sussed it - so I thought I'd post up in case ayone else searches for the answer. The central knob is made up of 3 parts. The round knob you can see, a red plastic insert and a clear plastic "tube". When you pull the knob off (can be very stiff) it may leave the clear tube behind and have the red "connector" piece inside the knob. The clear tube also pulls off, but its hard to get a grip on directly, so I used a cloth & screwdriver to leaver it off. Once off, you can get to the bulb as described above. Refitting - you push the clear tube back on, aligning a small slot at its base with a slither of plastic (basically, push & keep twisting until they align and the tube pushes home). The red piece then goes over the clear plastic tube and the knob pushes over that. TBH - Once you have them apart its obvious how to realign - the hardest bit was getting enough guts up to pull the knob off, as you really feel like its about to break something.

I tend to use a local motor factors but always check their prices against www.eurocarparts.co.uk as they have some good discount events on (you may need to wait until exhausts pop up on offer). If you use Euro car parts and have a local branch, call in and see if they will apply the online discounts. If they won't, pop outside, use your mobile to order & reserve the part you need, then walk back in the store to find the same man will sell you the same bit but now with a discount (I kid you not - I did exactly that at my local branch. It sounds crazy, but it got me 25% off!!!)

Sorry to resurrect an old thread, but does this work on the newer shaped knobs ? Mine are in a 2004 car and are a rubberised round knob about the diameter of a 50p rather than the type shown in the pic / video above. The centre knob doesn't seem to want to come off and I don't want to force it and break something.

Still after one

I spotted a Green Lupo being broken in Blackburn, Lancs and it still has all the bits you mentioned on it. The place is called JJ's - the owner is called Mark who was a really nice bloke. I called round for a engine pipe but he didn't have the bit I was after. I did however spot some tailored carpet mats which he charged me £2 for the full set. http://www.jjcarbreakers.co.uk/

Has nobody decatted and shoved their old pipe in the loft ?

Thanks for taking the pics. Must admnit I didn't think they would be that "blue". Let me have a think as they may clash with a yellow car. Out of interest - are you breaking the car or just stripping the interior ?

Could you post up some pics of the seats please ?

0.9 mm

Full set (Fronts & Rears) ? Any pics of the pattern / colour etc ?